This is an eight legged scorpion, six legged ant, forty four legged centipede.

Insects, those six legged organisms and spiders or mites, the eight legged organisms.

She was bare legged.

The spindle sweep measurement will show that the spindle axis is perpendicular to the table surface

Who don't listen are four legged.

Here we are talking a parasite not a two legged parasite, but an eight legged parasite, of course.

Place the work probe in the spindle

Attach the magnetic base to the spindle

Touch the spindle. Touch it, I say.

During automatic recovery, the spindle drawbar unclamps and you will hear a blast of air coming from the spindle nose

Along the bottom, we have the spindle information box with the override values for spindle speed, feed rate, and rapid rate

The spindle usually moves in the z axis.

The spindle warm up should now be complete

Attach the magnetic base to the spindle nose

Regardless of which tool ends up in the spindle

Remember, spindle speed also affects outside diameter holding force

The spindle will turn at a maximum of 750rpm

Sit in a cross legged posture, with spine comfortably erect.

Stiff legged, with long, lumbering steps, very slow and awkward.

And they already had a six legged robot called LEMUR.

Remove any tool that's in the spindle using TOOL RELEASE

Remove the fasteners holding the spindle head bracket in place

Select program O02020 Spindle Warm up and press SELECT PROGRAM

They ride horses. For the others, four legged donkeys are enough.

Man is two legged and the address to Man is marhaba.

How do the ones in four legged category understand? Giddy up!

And we'll keep the spindle speed below the recommended 900 rpm

With the machine geometry verified, start the Spindle Warm Up program

Cranes Order GruiformesFamily GruidaeCranes are large, long legged and long necked birds.

Nye So let's take a look at your eight legged friend here.

And he said especially with legged robots, because they're way too complicated.

Here's a legged version and a tractor version, or a bulldozer version.

I'll take him on myself but I can't bare bandy legged man.

If necessary, move the tailstock or 2nd spindle to the HOME position

To remove the spindle head bracket press Z , ZERO RETURN , and SlNGLE

Press CYCLE START and the spindle will begin turning at 500 rpm

Move the spindle head down to the middle of Z axis travel

Sit in a cross legged posture, and keep your hands open facing upward.

This is his address. You can't say marhaba to the four legged ones.

She lays her hands to the distaff, and her hands hold the spindle.

She layeth her hands to the spindle, and her hands hold the distaff.

Along the bottom, we have the spindle information box with the override display

Place boxes filled with packing foam under the spindle and tool carousel pocket

Detach the Red Security Bracket between the Turret Face and the Spindle Bulkhead

If your program spindle speed does exceed 750rpm, the program will not run