Install the Coolant Tank Handle onto the Tank

To clear the coolant tank

Before attaching the Coolant Level Sensor to the Coolant Tank, check that it shows the correct

lower end of the machine to maintain clearance to the coolant tank

Once the Coolant Tank is full operate the Coolant System to check that none of the connections just made are leaking

When the coolant tank is full, run each part of the coolant system to check that none of the connections are leaking

First, the machine is positioned at the correct height above the coolant tank

First, the Machine is set to the correct height to clear the Coolant Tank

Now is a good time to install the Coolant Tank and its related components

Make sure the machine is high enough off the ground to clear the coolant tank

When all coolant pump connections are complete ask the customer to fill the coolant tank so the connections that were just made can be tested for leaks

Before attaching the coolant level sensor to the coolant tank check that it registers the correct empty, 1 2 full, and full positions on the Current Commands page

With the rear side enclosure panels installed remove the brackets from side of the machine and the coolant tank area

Attach the three quarter inch Coolant Line from the Coolant Manifold to the standard Coolant Pump

When all Pump connections are complete ask the customer to fill the Coolant Tank so the system can be tested for leaks

While waiting for the customer to fill the Coolant Tank it's a good time to re check the incoming voltages for fluctuations

With the Chip Tray, Tank Lid, Gate Filter, and Standard Coolant Pump in place we are ready to make connections to the Machine

Place the standard coolant pump next and connect the 3 4 coolant line from the coolant manifold to the pump

Coolant level indicator

While you are waiting for the customer to fill the coolant tank it is a good time to re check the incoming voltages for fluctuations

Connect the electrical cord from the standard Coolant Pump to the receptacle labeled Coolant

The leveling procedure has three steps first, set the machine at the correct height to accommodate the coolant tank second, rough level front to back and side to side to promote proper coolant flow and finally, remove any twist in the base casting so the machine will cut accurately

When the sodium potassium alloy is used as a coolant in nuclear reactors, is created which makes the coolant radioactive.

Move to the coolant pump area and attach the wash down hose assembly to the mounting point on the coolant manifold

And I'm going to insert a coolant command

Tank support! We must have tank support!

Because your fuel is liquid, and it's combined with your coolant, you could actually just drain the core into what's called a sub critical setting, basically a tank underneath the reactor that has some neutrons absorbers.

I wanted to turn coolant on, I had forgotten it

And there is the coolant command inserted into the program

A tank!

Burning tank.

Maybe I forgot to turn coolant on before a particular tool

(iv) Tank Projectiles

Tank full yet?

It's a tank!

When the decays, it causes a buildup of magnesium in the coolant.

leaving the machine clean with nothing remaining to contaminate the customer's coolant

A significant modification was also made to the entry for primary coolant pumps

Tilt along this axis influences how coolant and chips drain from the lathe

Example 1 insulated tank

Civil Preliminary Clarification Tank

Fuel tank, 15,000 litre

Fuel tank, 7,500 litre

Fuel tank, 5,000 litre

Petrol tank plus metering