Turret

Cisco Turret

To the turret!

Have a little turret there.

This is going up into the turret.

Most of the men gathered by the turret.

I don't know. A tank, a turret, something.

Now, carefully remove tool T 2181 from the turret

Matyusshenko instructed the men to meet by the turret.

Jog the turret to the middle of X axis travel

This box will always display the current turret tool position

This turret holds five tools that have no existing offset data

Use the precision level vial parallel to the turret for this measurement

Detach the Red Security Bracket between the Turret Face and the Spindle Bulkhead

The other day I was watching them from the turret of the castle.

When the operator presses CYCLE START the turret will index to the tool we have entered in the Tool Number box and the turret will move to the probe and check the insert

The turret is at tool position number 12 and therefore the Tool Number box reads 12

With the turret a safe distance away move the probe arm into position by pressing F1

So, in order to get the intimacy, to share that experience with you, the guys the two most popular mounts there was a camera on the turret, the gun turret, and then on the dashboard of the Humvee.

So, in order to get the intimacy, to share that experience with you, the guys the two most popular mounts there was a camera on the turret, the gun turret, and then on the dashboard of the Humvee.

Now, note the reading of the longer precision leveling vial which is parallel to the turret face

Two men stay in it. One at the wheel, one at a machine gun in the turret.

Then, looking up in the turret, you see there are bulges and pokes and sags and so forth.

With the turret still beside the spindle note the exact position of the bubble in the vial window

But at length, as the labor drew nearer to its conclusion, there were admitted none into the turret.

So the men climbed up the turret and the first man touched the star and he was transformed instantly.

Then jog the turret along the Z axis towards the spindle getting to the end of Z travel if possible

With the first tool set, move the turret a safe distance from the probe arm, and index to the next tool

The first 15 tanks, produced between February and March 1934, did not include the rotating turret and were used for crew training.

We put it on a turret with a camera, so that when they shoot at you, you're over there, and it's there.

Once settled, move the turret back across full Z axis travel to the spindle side and note which direction the level is tilting

The turret will index to the tool selected in the Tool Number box and bring the tool to the probe and check the offsets

The IFV version is equipped with a 25 mm cannon and a 7.62 mm coaxial machine gun in a closed turret and it can carry 9 passengers.

If she is a wall, we will build on her a turret of silver. if she is a door, we will enclose her with boards of cedar. Beloved

Be sure to mount tool T 2181 so that the tool's surface is level to the ground and push the tool firmly against the turret face while installing

Installed into a protective wall surrounding the suburban home of Louis Novaes, who's the head of the Novaes family, are these turret holes, which were used for shooting and looking.

The other slot is for older SL Series machines depending on turret type, place the mounting arm either in an OD tool holder slot or a slotted VDI tool holder

The hull of the ship was a 'turret deck' design decks below the waterline were wider than those above water, and a flat, reinforced hull allowed the ship to rest on the bottom.

I got three tins of paint, Airfix paint that you use for models, and I was it was a big children's home, big Victorian children's home and I was in a little turret at the top of it, and I poured them, red, yellow and green, the colors of Africa, down the tiles.