Line thickness

Thickness

Thickness

Thickness

Border thickness

Font border thickness

(d) Antarctic Ice Thickness Monitoring Programme

(g) An increase in wall thickness provided the thickness stays within the range permitted by the welding procedures specifications

Two nanometers is 20 atoms in thickness.

Is the thickness of the crust okay?

And they're tiny. They're the thickness of a hair.

(i) a greater thickness of the same insulating material or

No thickness of enamel could conceal value from his eyes.

As for the pillars, the height of the one pillar was eighteen cubits and a line of twelve cubits encircled it and its thickness was four fingers. It was hollow.

So, for instance, he used his new ideas about light to deduce that the Earth's atmosphere is of a finite thickness, and he even estimated what that thickness is.

(a) A decrease in the initial maximum design temperature, not affecting thickness

(b) An increase in the initial minimum design temperature, not affecting thickness

The thickness of the Arctic decreased more than 40 percent since 1960.

Typically steel is rolled between sets of rollers to produce the final thickness.

(ii) the same thickness of a different insulating material having better insulation properties

So think about water flowing in pipes where the pipes have different thickness.

OK simply put, viscosity is the measure of the thickness of a fluid.

So think about water flowing in pipes, where the pipes have different thickness.

Knudsen layer thickness The knudsen layer thickness can be approximated by formula_1, given byformula_2,where formula_3 is Boltzmann's constant, formula_4 is the temperature, formula_5 is the molecular diameter and formula_6 is the pressure.

Pressure drums shall have a minimum wall thickness as specified by the competent authority.

Almost 98 of Anarctica is covered by ice at least one mile in thickness.

This pulley has sufficient wall thickness to allow us to use standard soft jaws

(h) A decrease of the maximum allowable working pressure, or maximum working pressure, not affecting thickness

(a) To understand the dynamic and thermodynamic processes determining the sea ice mass and thickness distribution

It's like measuring the thickness of a sheet of paper held edge on 100 miles away.

After about two to three weeks, we're looking at something which is about an inch in thickness.

When the length is considerably longer than the width and the thickness, the element is called a beam.

By making thickness measurements at multiple sites on the body you can calculate the estimated body fat percentage.

This process is repeated several hundred times until the required parameters such as coating thickness, etc., are achieved.

But this understates the seriousness of this particular problem because it doesn't show the thickness of the ice.

But all of the UVB, or nearly all of it, is dissipated through the thickness of the atmosphere.

The highest rates of working against gravity are required when the thickness of the crust (not the lithosphere) changes.

CryoSat will measure changes in the elevation of ice sheets and changes in sea ice thickness with unprecedented accuracy.

Because the blue line is a better line. The red line is way downhill, the blue line is a good line.

3. Line 1 line 2

4. Unencumbered balance (line 1 less line 2 less line 3)

Such white mineral deposits accumulate to a surface thickness of several millimeters and must be removed by chemical or mechanical means.

This line here and this line here, so this line and this

The red line is way downhill, the blue line is a good line.

The most common method is by using gun calipers to measure the thickness of subcutaneous fat in multiple places on the body.