Production Technora is produced by condensation polymerization of terephthaloyl chloride (TCl) with a mixture of p phenylenediamine (PPD) and 3,4' diaminodiphenylether (3,4' ODA).

Paraformaldehyde (PFA) is the smallest polyoxymethylene, the polymerization product of formaldehyde with a typical degree of polymerization of 8 100 units.

There is no condensation or corrosion within the tubes.

We can start harvesting condensation, and start greening the desert from within.

For most industrial purposes, degrees of polymerization in the thousands or tens of thousands are desired.

Nearly 600 industrial plants use radioisotopes, e.g. in food irradiation, polymerization, industrial radiography and oil well operations.

It turns out it isn't because of something called film condensation, and this explains that.

This is because of the condensation of water vapor in the air parcel due to expansion cooling.

Over the years, this shifting has created cracks which permit leakage to occur following condensation or pipe breakage.

This augments the natural process, where sea salt from the oceans provides water vapor with the cloud condensation nuclei.

Seeds triggering the conversion of vapor are referred to as condensation nuclei, as in the case of water vapor.

The fundamental interest of this kind of polymerization mineral obtained at room temperature is to preserve organic molecules or microorganisms that wishes to fit.

This approach will ensure that condensation does not occur on or to the inside of the vapor barrier during cold weather.

In organic chemistry, one of the first reaction mechanisms proposed was that for the benzoin condensation, put forward in 1903 by A. J. Lapworth.

Chain termination is any chemical reaction that ceases the formation of reactive intermediates in a chain propagation step in the course of a polymerization, effectively bringing it to a halt.

The 1 3 2 3 rule will ensure that the vapor barrier temperature will not fall below the dew point temperature of the interior air, and will minimize the possibility of cold weather condensation problems.

Another promising approach is marine cloud whitening, which sprays seawater droplets into marine clouds to make them reflect more sunlight. This augments the natural process, where sea salt from the oceans provides water vapor with the cloud condensation nuclei.

Although humidification technology could raise its relative humidity to comfortable middle levels, this is not done since humidity promotes corrosion to the inside of the hull and risks condensation which could short electrical systems, so for safety reasons it is deliberately kept to a low value, around 10 .