You can operate the chip conveyor in Setup mode but you must press and hold the conveyor key CHlP FWD

If a Chip Guide Bracket is included with the Conveyor Accessories, install it now

Ask someone to assist you to hold the weight of the Chip Conveyor while you unfasten the Shipping Security Screws and lower the Conveyor into position

Connect both coolant pump power cables as well as the power cable for the chip conveyor

With electricity supplied to the Conveyor press the CHlP FWD key to make sure the Conveyor Belt feeds smoothly with no binding or dragging inside the Enclosure and at the Chip Discharge Point

Note that any chip conveyor support screws or brackets should not be touching the ground until after the leveling procedure is complete

Start with the screws on the chip conveyor side followed by two of the four screws on the left side of the panel

We've got a conveyor there.

Those are conveyor belts that go around.

like a centaur on a conveyor belt.

Chip

Chip.

Chip!

Thank you, old chip. Not old chip, old chap!

Connect the Electrical Cable to the receptacle labeled Conveyor

It's all conveyor belt, and it makes a book.

Yes, Chip.

Slowly, Chip.

Chip, huh?

Hello, Chip.

Hello, Chip.

Reload, Chip.

One chip on the red, and one chip on the black.

A potato chip!

There's the chip.

You see Chip?

Chip, you care.

Okay, Chip? Okay?

Cheerio, old chip.

Is that you, Chip?

Hello. Oh, hello, Chip.

Thanks, Chip. I'm okay.

Have a potato chip.

I'll chip in too.

ABC obtains a loan from Lender B to finance the purchase and installation of the conveyor equipment from Vendor C, secured by a security right in the conveyor equipment.

It has in the past been combined with array technology (ChIP chip) with some success.

One chip color area sensor

Two chip color area sensor

Three chip color area sensor

It's a little paper chip.

Look, Chip, we tried before.

Change, to our mind, is like a conveyor belt endless and ever moving.

Route the Electrical Cable neatly from the Conveyor Motor down to the receptacle

Ah, ah! There it is. It's picked up the object off the conveyor.

Move to the Belt Tensioning Bolts and tighten them inwards towards the Conveyor Motor